|
Post by 71racer on Jan 28, 2019 3:38:10 GMT
How wide does everyone set there Murray wide body frame rails apart I’ve read 15” but wondering if there is better widths thanks
|
|
|
Post by thebandit21 on Jan 29, 2019 17:14:29 GMT
I would just go with 15" since that is legal USLMRA FXT/FXS width. You really don't want it any wider or you will have clearance problems in the front end plus its wide enough where you only need two axle bearings in the rear. If it's legal it will improve the resale value of the machine.
|
|
|
Post by 71racer on Jan 29, 2019 22:03:27 GMT
Ok thank you for the reply yet again lol I was trying to decide wether to go out to 15” or keep them a bit narrower and run a 3rd bearing and an right side 1/2 frame for the bearings on the axle and jackshaft but I guess that would make it offset? And more weight to the left side
|
|